- Screw-terminal connection for 10mm single-color LED strip light — available in strip-to-strip joint and strip-to-wire configurations to cover both splicing and power termination in the same installation
- Works with both flexible PCB and rigid LED strips — one of the few solderless connector types that handles rigid board strips, making it the right choice when the installation isn't limited to standard flexible tape
- No soldering required — insert the strip and wire into the connector, then tighten the terminal screws with a small flathead screwdriver to lock both conductors in place. Accepts 22–16 AWG wire (0.32–1.32 mm²) on the cable side, covering everything from light 22AWG signal leads to heavier 16AWG power runs
- The screw-fixed mechanical clamp delivers a more permanent, pull-resistant connection than spring-clip or pierce-to-contact alternatives — useful in installations where vibration, thermal cycling, or periodic maintenance could otherwise loosen a connection over time
- Transparent polycarbonate housing lets you confirm pad alignment and wire seating before tightening — reduces the chance of a miswired connection going unnoticed until the strip is already mounted
- Rated DC 5–24V and up to 6A, covering the full range of 12V and 24V single-color LED strip systems
- IP20 rated for indoor use — suitable for under-cabinet, cove, shelf, display, and furniture lighting where the strip is not exposed to moisture
- CE and RoHS certified
The screw-fix approach takes a few more seconds than a clamp connector, but what you get in return is a mechanically locked connection that stays put. If you're working with rigid strip, running long permanent runs, or installing in a location that's hard to reach for a redo — this is the connector to use.
